EasyManua.ls Logo

SMC Networks EtherCAT EX260-VEC1 - Page 8

SMC Networks EtherCAT EX260-VEC1
33 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-8-
No.DOC1048575-1
•Mount the product in a place that is not exposed to excessive vibration or impact.
Otherwise, failure or malfunction can result.
•Do not use the product in an environment that is exposed to temperature cycle.
Heat cycles other than ordinary changes in temperature can adversely affect the inside of the product.
•Do not expose the product to direct sunlight.
If using in a location directly exposed to sunlight, shade the product from the sunlight.
Otherwise, failure or malfunction can result.
•Keep within the specified ambient temperature range.
Otherwise, malfunction can result.
•Do not operate close to a heat source, or in a location exposed to radiant heat.
Otherwise, malfunction can result.
•Use with caution at altitudes above 2000 m, as the reduction in atmospheric pressure reduces withstand
voltage performance and noise immunity. (lightning surge, electro-static discharge)
Adjustment and Operation
•Perform settings suitable for the operating conditions.
Incorrect setting can cause operation failure.
•Please refer to the controller manufacturer's manual etc. for details of programming and addresses.
For the protocol and programming refer to the relevant controller manufacturer's documentation.
Maintenance
•Turn off the power supply, stop the supplied air, exhaust the residual pressure and verify the release of
air before performing maintenance.
There is a risk of unexpected malfunction.
•Perform regular maintenance and inspections.
There is a risk of unexpected malfunction.
•After maintenance is complete, perform appropriate functional inspections.
Stop operation if the equipment does not function properly.
Otherwise, safety is not assured due to an unexpected malfunction or incorrect operation.
•Do not use solvents such as benzene, thinner etc. to clean each unit.
They could damage the surface of the body and erase the markings on the body.
Use a soft cloth to remove stains.
For heavy stains, use a cloth soaked with diluted neutral detergent and fully squeezed, then wipe up the stains again with
a dry cloth.

Related product manuals