SMC Networks PF2MC7 Series - Page 70

-69-
No.PF※※-OMZ0002
Analogue output check
Press the UP or DOWN button
to select analogue output
check.
∗: When 0-10V is selected for voltage output type, [ 0.0] ⇔ [ 10.0]
is displayed.
∗: For current output type, [ 4] ⇔ [ 20] is displayed.
PD diagnostic bit (flow) check
Press the UP or DOWN button
to select diagnostic bit (flow)
check.
∗: This function is available with IO-Link communication.
∗: Refer to page 82 for details of the diagnostic information.
Press the SET button to set.
Move on to PD diagnostic
bit (flow) check
.
When the product is used in
SDCI mode (IO
-Link)
Press the SET button to set.
Mo
ve on to the PD
diagnostic bit check.
When the product is used in
SIO mode
Press the
SET button to set.
Move on
to function
selection mode.