-70-
No.PF※※-OMZ0002
PD diagnostic bit (error) check
Press the UP or DOWN button
to select diagnostic bit (error)
check.
∗: This function is available with IO-Link communication.
∗: Refer to page 82 for details of the diagnostic information.
Press the SET button to set.
PD flow measurement check
Press the UP or DOWN button
to select PD flow
measurement check.
∗: This function is available with IO-Link communication.
Press the SET button to set.
[F98] Setting of output check completed.
∗: Measurement mode can return from any setting item by pressing the SET button for 2 seconds or longer.
∗: An increase or decrease in flow will have no effect on the output while the output operation is being performed.
∗: PD stands for Process data. Refer to page 77 for further details of the PD.
Move on to PD diagnostic
bit (flow) check
.
Return to function
selecti
on mode.
To Next Page
Loading...
