C
ONFIGURING
THE
S
WITCH
10
is attached. (Note that the management station must always be on VLAN
1) Valid IP addresses consist of four numbers, 0 to 255, separated by
periods.
• Subnet Mask – This mask identifies the host address bits used for
routing to specific subnets. (Default: 255.255.255.0)
• Gateway IP Address – IP address of the gateway router between the
stack and management stations that exist on other network segments.
(Default: 0.0.0.0)
•MAC Address – The physical layer address.
Port Information
•Type – Indicates the port type.
•Link Status – Indicates if the link is Up or Down.
• Speed/Duplex Status – Shows the current speed and duplex mode.
Displays a number, the speed in Mbps, followed by either "fdx" for
full-duplex or "hdx" for half-duplex.
• Flow Control Status – Indicates whether flow control is enabled or
disabled.
• Autonegotiation – Shows if auto-negotiation is enabled or disabled.
• Frame Type – Either "Tagged" or "All". "Tagged" means that the port
will only send and receive VLAN-tagged packets. When set to "All", the
port will also send and receive untagged packets.
•PVID – VLAN ID assigned to untagged frames received on the
interface. (Default: 1)
Trunk Information
• Trunk – The trunk label. "T1" through "T8" are used as trunk labels.
•Type – All trunks and ports on this switch are 10/100/1000M
• Trunk Status – An indication of the speed and duplex setting of the
trunk. This is a number, the speed in Mbps, followed by either “Full” for
full-duplex or “Half” for half-duplex. This can be changed on the
TRUNKS > Settings page.
•Ports – The ports that are members of the trunk.
To Next Page
Loading...
Need help?
General
