SMC Networks TigerStack II SMC8848M

I NSTALLING THE S WITCH
3-12
Connecting to a Power Source
To connect a device to a power source:
1. Insert the power cable plug directly into the socket located at the back
of the device.
Figure 3-8 Power Socket
2. Plug the other end of the cable into a grounded, 3-pin, AC power
source.
Note: For international use, you may need to change the AC line
cord. You must use a line cord set that has been approved for
the socket type in your country.
3. Check the front-panel LEDs as the device is powered on to be sure
the Power LED is on. If not, check that the power cable is correctly
plugged in.
4. If you have purchased a Redundant Power Supply, connect it to the
switch and to an AC power source now, following the instructions
included with the package.