SMC Networks ZK2-ZSV-A Series - F11 Display Resolution

-33-
NO.ZK2-OM00501-B
■[F11] Display resolution
This function is used to change the pressure display resolution.
This can be used to prevent the digits from flickering on the display.
<Operation>
Press the or button in function selection mode to display [F11].
Press the button. Move on to setting of display resolution.
Press the button to set. Return to function selection mode.
Setting of [F11] Display resolution completed.
: It may not be possible to change the resolution depending on the unit of pressure selected..
The units that allow display resolution to be selected are MPa, kPa, kgf/cm
2
, psi and inHg.
(The units kgf/cm
2
, bar, psi and inHg can only be set when using a product with unit conversion function.)
[F 0] Unit selection function on page 24.
Setting of display resolution
Press the
or
button to select display resolution.