EasyManua.ls Logo

Smeg SW262 - 5.3 Using detergent and rinse aid; 5.3.1 Correct use of peristaltic pumps

Smeg SW262
37 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
13
5.3 Using detergent and rinse aid
The machine is equipped with a device for dosing the detergent and rinse aid, mounted inside the door. Except
for the prewash cycle, you must fill the dispenser with the proper amount of detergent before each wash.
WARNING: If optional peristaltic pumps P1 and P2 are installed, do not use the door dispenser since it is
disabled electrically (the door remains always shut)
Open the cover of the detergent dispenser with its lever. Now fill with detergent and close again carefully.
To fill up the rinse aid, remove the cap and fill to the level shown by the indicator (D).
MAX
MIN
fig. 10 Powder detergent and rinse aid dispenser, accessible with the door open.
During the wash cycle, the dispenser will open automatically.
Make sure to use good quality detergent for best results. Keep the detergent containers closed and in a dry
place to prevent lumps forming, as these can compromise the wash.
IMPORTANT!
Use powder detergent and not detergent tablets for short cycles
5.3.1 Correct use of the peristaltic pumps OPTIONAL
WARNING
The peristaltic pumps must be installed by a technician authorised to do so by Smeg.
After installation, they must be enabled (see SET-UP)
In this case, do not use the door dispenser; the machine must be hooked up to the detergent (red hose) and
rinse aid (transparent hose) containers.
After the containers have been opened, they must not be kept for too long since the detergent loses its power
and can form lumps which compromise the wash cycle.

Table of Contents

Other manuals for Smeg SW262

Related product manuals