31
The dishwasher filters are not clogged.
3. If the load is not properly cleaned, check that:
The correct amount of detergent has been added.
The salt container is not empty.
The tableware has been loaded correctly.
The selected program is suitable for the type and degree of soiling.
All filters are clean and correctly installed.
The spray arm nozzles are not clogged.
There is nothing obstructing the rotation of the spray arms.
Check that the salt container cap is properly closed.
4. If the tableware does not dry properly or remains matt, check that:
The intake filters rinse aid are clean
The rinse aid container is not empty.
The rinse aid dispenser setting is correct.
The detergent used is of good quality and has not lost its effectiveness (for example, through incorrect
storage, with the box left open).
Check that the salt container cap is properly closed.
5. If the tableware is streaky, stained or similar, check that:
The rinse aid dispenser setting is not too high.
6. If there are traces of rust in the dishwasher:
The tank is made of stainless steel, and therefore any rust marks are due to external elements (fragments
of rust from the water pipes, etc.). Special products are available to remove such marks.
Check that the detergent dose being used is correct. Certain detergents can be more corrosive than
others.
Check that the salt container cap is properly closed.
If the problem persists after following the troubleshooting instructions above, call the nearest Authorised
Service Centre.
7.5.2 Alarms
We list the dishwasher's alarms below, divided into "FATAL" and "NON-FATAL".
- In the first case, FATAL ALARMS the control panel displays "AF" followed by the alarm code.
- In the second case, NON-FATAL ALARMS, these are simple warnings and not malfunctions; the
message "A-" displays, followed by the alarm code. Press Start/Pause to continue using the machine.
ALARM EVENTS - READ CAREFULLY
When an alarm event occurs, the dishwasher automatically runs a safety shutdown. In such cases, the
alarm code on the display flashes until automatic handling has terminated: THE MACHINE CANNOT
BE RESET when it is in this condition.
Any RESET forced by the user will not be accepted until the problem has been dealt with and the
alarm code on the display is “steady”.
When an alarm is reported: Identify the code and its meaning in this table, along with the
suggested countermeasures. Apply the countermeasures for the case in question.
The user is typically required to proceed as follows:
1. First execute the DEFAULT PROCEDURE.
2. If the alarm does not cancel itself, execute the RESTORE PROCEDURE.
1. DEFAULT PROCEDURE
To Next Page
Loading...
