fig. 16 – Chamber drain filter, disassembly procedure and view of parts.
External circular filter
To remove this filter:
Take hold of the conical filter's tabs and turn anticlockwise (box A).
Without pressing the tabs, lift the assembly (box B).
When cleaning this filter, the others should also be cleaned.
How to mount the filters:
Put the external steel filter in place;
Insert the cone-shaped loosen filter into the steel filter by pressing its external edges slightly (box A);
Rotate the cone-shaped filter clockwise about 90° and then as far in as it goes.
Good maintenance tips
The filters should be cleaned under running water using a stiff brush.
It is essential to thoroughly clean the filters according to the above instructions: the dishwasher cannot
function if the filters are clogged.
Restore the filters before running a wash cycle.
7.4 Description of maintenance and cleaning by the authorised technician
Described in document reserved for authorised technicians.
7.5 Diagnostics, reporting and troubleshooting
7.5.1 ELIMINATING SMALL FAULTS
In some cases it is possible to remedy minor problems by referring to the following instructions.
1. If the program does not start, check that:
The dishwasher is connected to the mains.
There is no power outage.
The water cock is open.
The dishwasher door is properly closed.
2. If water is left inside the dishwasher, check that:
The drain hose is not kinked.
The drain trap is not blocked.
To Next Page
Loading...
