Replace any faulty parts only with original spare parts. The manufacturer is not liable in any way for
damage resulting from the use of unauthorised spare parts.
The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above
regulations or deriving from tampering with even just one part of the appliance and the use of non-original spare
parts.
Read this information carefully.
Symbol to the side of especially important instructions or information.
At the end of its life, the dishwasher may be contaminated,
especially as regards the tank and plumbing circuit (e.g. if put out of service due to a fault which
compromised the effectiveness of the last wash cycle): observe all appropriate precautions when
scrapping it. This appliance is marked in compliance with European Directive 2002/96/EC on waste
electrical and electronic equipment (WEEE). Make sure that this product is scrapped correctly to
safeguard the environment and health.
Caution, danger: refer to the manual.
Symbol on the product's nameplate, used to underline the need to read the manual before operating
the dishwasher. The symbol is also used in the manual next to safety information and instructions.
Caution - electrocution hazard.
Symbol located next to live equipment – disconnect the power supply before working on such
equipment. Do not touch live equipment if the power supply has not been disconnected.
4 PREPARING THE APPLIANCE FOR USE
4.1 Removing the packaging, inspection
After removing the packaging (straps, cardboard, wooden base and PVC cover) check the condition of the
appliance; the filling and drain hoses, power cable, and metal parts must all be securely fixed and undamaged.
4.2 Scrapping the packaging material
The packaging components (plastic bags, expanded polystyrene, nails, etc.) must not be left within reach of
children and pets since they are potentially dangerous. All packaging materials used are environment-friendly.
They can be kept without constituting any hazard, or may be disposed of at a specialist waste disposal centre.
Plastic components suitable for recycling are marked as follows: PE polyethylene: external packaging film, bag
containing the instructions, protective bags. PP polypropylene: straps. PS expanded polystyrene: protective
To Next Page
Loading...
