Smeg SW262 - 6.1.2 SET menu; 6.1.3 Parameter SET 3

26
Set
PARAMETER
DESCRIPTION
POSSIBLE
USER ACTION
POSSIBLE
TECHNICIAN
ACTION
1 –
Detergent pump P1 batching.
Set the ml/l, the default setting is 3 = 3 ml/l.
(The max. setting is 10 = 9.8 ml/l)
Increase/decrease the setting with the Select buttons.
X
X
2 –
Rinse aid pump P2 batching.
Set the ml/l, the default setting is 0,5 = 0,5 ml/l.
(The max. setting is 10 = 1.35 ml/l)
Increase/decrease the setting with the Select buttons.
X
X
3 –
Water hardness
Set the hardness in °f, in steps of 5. Range: 0-65°f. The
default is 40°f.
Attention: Make sure that the value corresponds to the
actual hardness of the water supply.
X
X
4 –
Additive dispensing type
- dd (powder detergent dispenser)
- PP (peristaltic pumps)
The default is “DD”. Enabling the peristaltic pumps
disables the powder dispenser.
X
X
SEr
Entering the configuration menu
Access to this menu is reserved for technicians for
setting up the dishwasher, and is password protected.
--
X
Table of peristaltic pump batching settings:
SET 1 – Detergent
SET 2 – Rinse aid
Value
ml / liter water
Value
ml / liter water
1
1
01
0,1
2
2
02
0,2
3
default
3
03
0,3
4
4
04
0,4
5
5
05
default
0,5
6
6
06
0,6
7
7
07
0,7
8
8
08
0,8
9
9
09
0,9
10
10
10
1
Move from one parameter to the next with A and B ; change the settings with and and
confirm them by holding down .
To quit Set mode, hold down .ù
6.1.3 Parameter “SET 3“