Smeg SW262 - 5.14.1 Running a RESET procedure; 6 Setup Mode and Functions; 6.1 Entering set-up mode; 6.1.1 Entering the USER menu

25
5.14.1 Running a RESET procedure
In case of alarm or with the dishwasher stopped: press and hold down the Start/Pause and DRAIN buttons
together for 2 seconds, until a beep sounds.
The display reads "P-" and the RESET starts.
At the end of the procedure, the display flashes "E-" alternating with the program number, if you are resetting
a previously interrupted program, or “End” alternating with “P –“ if you have reset the machine of your own
accord.
ATTENTION
If you are unable to run a RESET, before contacting technical service please turn the machine off and
on and try again.
6 SETUP MODE AND FUNCTIONS
The dishwasher has a set-up mode for changing its settings.
The washing parameters are not password protected, but the configuration parameters are.
6.1 Entering set-up mode
6.1.1 Entering the USER menu
To enter the wash settings menu, hold down the DRAIN button until the control panel displays “unlo” and then
flashes “Set”: release and press the button again immediately, this accesses the USER menu.
In the USER menu you can scroll through the following options with the “A” and “B” buttons:
USER menu options
Description
SET
Sets the dishwasher parameters – see Par. “Set” PARAMETERS for details
Cloc
Time and date – see Par. “CLOC” - DATE AND TIME PARAMETERS for details
Coun
Total hours of operation counter (read only, cannot be modified).
This parameter displays on two consecutive screens. The thousands value is followed
by “t”, the units value by “u”.
To enter a specific option, press the Start/Pause button.
To return to a higher level, press Open Door.
6.1.2 SET menu
The display reads Set.
To select this option, press .
The Set option has a variety of individual settings.