Chapter 1 - General standards and recommendations
10
The machine is shipped to the Customer ready to be installed, after it has passed all of the
foreseen tests and inspections in the factory, in compliance with legislation in force. The
warranty has a 365 day validity starting from the date of purchase. During the period covered
by warranty, SMIPACK commits itself to remove any faults or defects as long as periodical
maintenance is performed and original parts are always used. Expendable materials, parts
subject to normal wear or breakage, faults caused by atmospheric agents, transporting the
machine to an assistance centre and labour charges are excluded from the warranty. The
warranty is only valid for the original purchaser and only if the warranty certificate is properly
filled out in every part and sent within 20 days from the date of purchase. Repairs carried out
covered by the warranty do not interrupt or extend the warranty period.
The warranty will become void and invalid immediately in the following cases:
> improper use of the machine
> variation of process conditions
> unauthorised tampering by third parties
> failure to comply with that indicated in the instruction manual
> failure to use the manufacturer's original spare parts
1.3 REFERENTIAL STANDARDS
The machine models contained in this manual comply with Legislative Provisions which
transpose the following Directives.
European Directives applied to the equipment and/or the assembly:
• 2006/42/EC - Directive concerning the approximation of the laws of Member states relating
to machinery.
• 2006/95/EC - Directive concerning low voltage.
• 2004/108/EC - Directive concerning electromagnetic compatibility.
Technical standards applied to the equipment and/or the assembly:
• EN ISO 12100: 2010 - Safety of machinery - General design principles - Risk assessment
and risk reduction.
• EN ISO 13849-1:2008 + AC:2009 - Safety of machinery - Safety-related parts of control
systems - Part 1: general principles for design.
• IEC EN 60204-1:2006-06 - Safety of machinery - Electrical equipment of machines - Part
1: general rules.
1.4 SYMBOLS KEY
All of the instructions and information contained in this manual are often associated with certain
simple. Their meaning is explained in the following table.
To Next Page
Loading...
