Chapter 2 - Machine installation
16
2.4 TRANSPORTATION AND UNPACKING
SMIPACK S.p.A., depending on the type of transportation and products to be delivered, uses
adequate packaging to guarantee integrity and preservation during transportation.
Handle with care when transporting and positioning the
machine. The carrier is liable for damage sustained
during transportation. Be careful not to damage the
exposed parts when unpacking the unit. The machine
module must be handled from beneath. Due to the type
of packaging, systems that work from above cannot be
used.
Lift the machine in the middle from the longest side and
adjust the position of the fork-lift truck at the greatest
centred position possible.
ATTENTION!
Before handling, always make sure that the lifting device is suitable to lift the load.
For prolonged storage, place the machine in a covered area at a temperature ranging from -
15 °C to +55 °C, with a humidity degree between 30% and 90% without condensation.
2.5 ASSEMBLY BY USER
This section describes the assembly processes which must be carried out by the user
according to the user's own requirements.
1) ASSEMBLY OF THE WHELLS
• Remove the supports 1 of the machine attached to the pallet.
• Keeping up the machine using a fork-lift truck mount the wheels as shown in the figure.
To Next Page
Loading...
