Smipack FP560 - Electrical Installation Data; Conditions for Machine Use; Demolition and Waste Disposal

Use and maintenance manual FP560 - FP560A - FP870A
21
2.7 ELECTRICAL INSTALLATION DATA
Install a circuit breaker on the machine power supply line which supports the values indicated
in the table.
2.8 CONDITIONS FOR USE
Make sure there is room for easy application and maintenance.
The machine must be installed in a closed, well-ventilated area where there are no
explosion or fire hazards.
The minimum lighting must be 300 lux.
Position the machine in a place free of humidity, flammable materials, gas or explosives. Make
sure that it is level. Operating temperatures ranging from +10°C to +40°C are recommended,
with a relative humidity from 30% to 80% without condensation.
DECLARED NOISE EMISSION VALUES IN COMPLIANCE WITH THE STANDARD ISO
4871 ARE:
THE A-WEIGHTED EMISSION SOUND PRESSURE LEVEL (AT OPERATOR POSITION)
DOES NOT EXCEED 70 dB.
Machine protection degree = IP30
ATTENTION!
Noise pressure and power on the machinery plate can vary depending on the material
of the containers to be packed. The user must therefore evaluate the noise exposure of
one's personnel depending on the type of packaging processed, so that the operators
can be provided with adequate personal protection equipment.
2.9 DEMOLITION AND WASTE DISPOSAL
The machine does not contain dangerous components or substances which require special
disposal procedures. For that which concerns material elimination, comply with the Standards
in the country where the machine has been disassembled.
FP560 FP560A FP870A
Nominal
voltage
220÷240 V
(1PH+N+PE)
220÷240 V
(1PH+N+PE)
220÷240 V
(1PH+N+PE)
Nominal
frequency
50÷60 Hz 50÷60 Hz 50÷60 Hz
Nominal
power
2450 W 2500 W 3100 W
Nominal
current
11,5 A 12 A 15 A