Use and maintenance manual FP560 - FP560A - FP870A
29
4.1 POSITIONING REEL AND FILM PASSAGE
• Insert the film reel in the reel holder 1 blocking it with the self-centring tapered supports 2.
• Pass the film through the perforators 3.
• Pass the lower edge of the film below the packaging plate 4 and the upper edge above at.
4.2 ADJUSTING FILM PERFORATORS
The number of punches required varies according to the width of the packs to be sealed. A
single punch is sufficient for small packs. On the series FP560-FP560A machines there are two
punches available while there are three for model FP870A.
Turning the perforators manually A you can move them closer or farther from the contrast B to
obtain a larger or smaller perforation thus guaranteeing ideal heat shrinking for any type of
product without breaking the film along the sealing.
CHAPTER 4 - PREPARING THE MACHINE FOR USE
To Next Page
Loading...
