28
EEWB330B
If b
alancing optimization (silent running) has been
carried
out
correctly
according
to
the program cycle,
after the check run the machine automatically returns
to the type of weight positioning previously selected and
indicates the residual dynamic imbalance on the wheel.
• Balance the wheel according to the readings.
Both optimization and balancing are accomplished.
Message E9
Message E9 means that at least one error occurred
during the optimization cycle. Press the STOP key (5)
to exit the optimization program and repeat optimization
if necessary.
Option 2: do not adjust the tire on the rim
• Press the STOP key (5
) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
• Balance the wheel according to the readings.
Reading H0
• Press the STOP key (5) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
• Balance the wheel according to the readings.
The optimum balancing optimization condition has been
achieved and cannot be improved.
Reading H2
Silent wheel running cannot be improved. However, it
is possible to achieve weight minimization (readings
with code UN.).
Option 1: Weight minimization
• Press the FINE key (3) to continue the program.
As a result reading is II - Un.7 or Un.7 - II
Option 2: Abort optimization
• Press the STOP key (5
) to exit the OP program and
return to the balancing program.
The imbalance on the wheel is shown on the readout.
• Balance the wheel according to the readings.
5-34
5-35
5-32
1
2
3
4
5
To Next Page
Loading...
Need help?
General
