Sno-Tek 24E - Install Engine

EN – 26
7. Remove hardware securing engine mount to frame.
See Figure 52.
8. Using a suitable lifting device or help from an adult
assistant, lift engine and tilt forward slightly to relieve
tension from belts. Remove belts from engine
sheaves. See Figure 53.
9. Lower engine onto a flat, level surface.
See Figure 54.
10. Remove hardware securing attachment sheave to
crankshaft.
11. Remove attachment sheave and traction sheave
halves from crankshaft.
Install Engine
1. Using a suitable lifting device or help from an adult
assistant, lift engine and lower onto bolts in frame.
2. Position belts over crankshaft.
3. Secure engine mount to frame with four lock washers
and four hex nuts. Torque to 11.9 N•m – 17.9 N•m
(8.8 lb-ft – 13.2 lb-ft).
See Figure 55.
4. Reinstall traction sheave halves onto crankshaft.
IMPORTANT: Traction sheave halves must be reinstalled
in the orientation shown in Figure 55.
5. Reinstall traction drive belt onto traction sheave.
6. Reinstall attachment sheave onto crankshaft.
WARNING: AVOID INJURY. Engine is heavy.
NEVER lift engine without a suitable lifting device
or adult assistant.
Figure 52
Figure 53
WARNING: AVOID INJURY. Engine is heavy.
NEVER lift engine without a suitable lifting device
or adult assistant.
Figure 54