EasyManuals Logo

Snorkel TM12 Service Manual

Snorkel TM12
107 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
Hydraulics Section 3 - Service & Repair
Page 3-10
H
YDRAULIC
P
UMP
The Hydraulic Pump is located in the Power Module, and is mounted on the rear of the motor.
R
EMOVAL
NOTE: If the hydraulic tank has not been drained, suitable means for plugging the hoses should be provided to prevent
excessive fluid loss.
1. Mark, disconnect and plug the hose assemblies.
2. Loosen the capscrews and remove the pump assembly from the motor.
I
NSTALLATION
Figure 3-6: Hydraulic Pump
1. Lubricate the pump shaft with general purpose
grease and attach the pump to the motor with
the capscrews.
2. Using a crisscross pattern, torque each cap-
screw a little at a time until all capscrews are
torqued to 27N-m (20 ft-lbs).
3. Unplug and reconnect the hydraulic hoses.
4. Check the oil level in the hydraulic tank before
operating the work platform.
C
YLINDER
VALVE
A
SSEMBLY
1
2
3
5
4
1. Inlet Hose
2. Outlet Hose
3. Capscrew
4. Pump Assembly
5. Electric Motor

Other manuals for Snorkel TM12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Snorkel TM12 and is the answer not in the manual?

Snorkel TM12 Specifications

General IconGeneral
BrandSnorkel
ModelTM12
CategoryLifting Systems
LanguageEnglish

Related product manuals