SolarEdge StorEdge SE10K-RWS Installation Guide

Chapter 1: Overview
SolarEdge’s StorEdge™ solution for Smart Energy Management, enables connecting a
battery to the inverter.
Power is stored in the battery and can be used for various applications such as
maximized self-consumption and time of use profile programming. For backup power,
an inverter specifically designed for backup applications is required; this inverter is not
in the scope of this document.
The StorEdge Solution Components
StorEdge Inverter is connected to a battery and supplies control and monitoring
signals to the battery for operation, in addition to its traditional functionality as a
DC-optimized PV inverter.
Energy Meter - The meter is used by the inverter for export/ consumption readings,
and for Smart Energy Management applications, such as: export limitation, and
maximizing self-consumption.
Battery - A 48V battery designed to work with the StorEdge system. Make sure to
use SolarEdge-approved batteries only.
Figure 1: StorEdge system components
StorEdge Three Phase Inverter MAN-01-00648-1.3
10 Chapter 1: Overview

SolarEdge StorEdge SE10K-RWS Specifications

General

Topology	Transformerless
Max Efficiency	98.3%
Dimensions	540 x 315 x 260 mm
Noise Level	< 50 dBA
Protection Rating	IP65
Rated AC Power	10000 W
AC Frequency	50/60 Hz
Maximum Efficiency	98.3%
Number of MPP Trackers	1
Warranty	12 years
AC Output Power	10000 W
Operating Temperature Range	-25°C to +60°C
AC Voltage	230 / 400 Vac
Max Input DC Voltage	480 V
Communication Interfaces	Ethernet, RS485, ZigBee (optional)
Max Charge/Discharge Current	25 A
Max Charge/Discharge Power	10000 W
Communication	Ethernet, RS485, ZigBee (optional)