SolarEdge StorEdge SE10K-RWS Installation Guide

Connecting the Grounding Cable
Connect the grounding cable from the battery to the grounding hole on the side of
the inverter, as shown below. Use an M6 screw.
Figure 18: Grounding the battery
Closing the Inverter Cover
1. Mount the cover.
2.
Fasten all bolts slightly with a hand, so that they hold the cover.
StorEdge Three Phase Inverter MAN-01-00648-1.3
39 Closing the Inverter Cover

SolarEdge StorEdge SE10K-RWS Specifications

General

Topology	Transformerless
Max Efficiency	98.3%
Dimensions	540 x 315 x 260 mm
Noise Level	< 50 dBA
Protection Rating	IP65
Rated AC Power	10000 W
AC Frequency	50/60 Hz
Maximum Efficiency	98.3%
Number of MPP Trackers	1
Warranty	12 years
AC Output Power	10000 W
Operating Temperature Range	-25°C to +60°C
AC Voltage	230 / 400 Vac
Max Input DC Voltage	480 V
Communication Interfaces	Ethernet, RS485, ZigBee (optional)
Max Charge/Discharge Current	25 A
Max Charge/Discharge Power	10000 W
Communication	Ethernet, RS485, ZigBee (optional)