46
10.2.4 Error
Status LED: red
Status message Cause Step
Device error (+ error code) An internal fault has occurred
in the inverter.
Note the displayed, two-digit
error code and contact the
SolarMax Service Centre.
10.2.5 Blockings
Status LED: flashes red
Status message Cause Step
External blocking There is a 0% command from
MaxRemote (coming from the
grid operator).
None. Wait until the grid
operator suspends the
blocking of the inverter via
MaxRemote.
10.2.6 Error messages during the initialisation phase
The following faults occur only during the inverter initialisation phase and indicate a de-
fect in the inverter (device fault).
Display status LED: does not glow
Error message Steps
SUPPLY FAULT
Notify the SolarMax Service Centre.
ADC REFERENCE ERROR
ERROR EEPROM
CONFIGURATION ERROR
IRRADIANCE TOO LOW Wait until irradiance is high enough.
To Next Page
Loading...
