63 • Control Keypad
________________________________________________________________________________________________
7.5.2 View Software Version
Press the Mode and ▼ keys simultaneously.
The LCD will display:
TEST/MAINTENANCE
***OPTIONS***
Press the Select key twice.
The LCD will display:
BTL-R-16/09/2008
STRT.DN-270109
Press the Mode and ▼ keys simultaneously to exit the TEST/MAINTENANCE mode.
The LCD will display:
% OF MOTOR FLA
7.5.3 Obtain Default Parameters
Press the Mode and ▼ keys simultaneously.
The LCD will display:
TEST/MAINTENANCE
***OPTIONS***
Press the Select key three times.
The LCD will display:
STORE ENABLE
DEFAULT PARAMET.
Press the Store + Mode keys simultaneously.
The LCD will display:
DATA SAVED OK
And after a few seconds the LCD will display:
% OF MOTOR FLA
CAUTION!
Obtaining DEFAULT PARAMETERS erases all previously modified settings
and requires the operator to reprogram all parameters that differ from the
factory default.
Note: It is especially important to reprogram the FLC (as shown on the label of
the RVS-DN), FLA and voltage protection values again.
7.5.4 Reset Statistical Data
Press the Mode and ▼ keys simultaneously.
The LCD will display:
TEST/MAINTENANCE
***OPTIONS***
Press the Select key four times.
The LCD will display:
RESET STATISTICS
Press the Reset + Store keys simultaneously.
The LCD will display:
DATA SAVED OK
And after a few seconds the LCD will display:
STATISTICAL DATA
- **** -
Press the Mode and go back to:
% OF MOTOR FLA
To Next Page
Loading...
Need help?
General
