Front Panel
22
LED's Arrangement
On
Lights up when Control Supply voltage is connected to
the starter.
Start
Lights up during start process, indicating that motor
supply voltage is ramping up.
Run
Lights up after completion of starting process,
indicating that motor is receiving full voltage.
Flashes during slow speed operation.
S. Stop
Lights up during Soft Stop process, indicating that
motor supply voltage is ramping down.
Stop
Lights up when motor is stopped.
E. Save / Slow
Lights up when “Energy Save” is in operation.
Flashes when motor is running at Slow Speed.
D. Adj. / Rev
Lights up when Dual Adjustment is in operation.
Flashes when motor is running in the Reverse direction
at slow speed.
Fault
Lights up upon operation of any of the built-in
protection.
Flashes when Insulation Alarm (optional) relay is
activated
Keypad
Provides selection of the following
modes:
(When Dip Switch 1 is in “On”, gray
zone shows list of maximized
parameters).
• Display Only
• Main Parameters
• Start Parameters
• Stop Parameters
• Statistical Data
• Dual-Adjustment Parameters
• Energy Saver and Slow Speed
Parameters
• Fault Parameters
• I/O Programming Parameters
• Communication Parameters
To select function within each mode.
To increase adjusted parameters.
Press momentarily or continuously.
To decrease adjusted parameters.
To save modified parameters.
To reset the starter after fault has been
removed, canceling the displayed fault
and allows restarting.
Note: Pressing Mode or Select continuously
increases parameters changing speed.
Store
Reset
To Next Page
Loading...
Need help?
General
