THERMOCUBE II 200-650W THERMOELECTRIC CHILLER MANUAL 52-14790-1
SOLID STATE COOLING SYSTEMS, 167 MYERS CORNERS ROAD, WAPPINGERS FALLS, NY 12590 12
TELEPHONE: (845) 296-1300, FAX: (845) 296-1303, WEB: WWW.SSCOOLING.COM VERSION M2
3.3 AIR CONSIDERATIONS
The air inlet and outlet are located on the left and right sides
respectively. Restricting airflow into or out of the unit will impair
performance. At least 3 inches of clearance is required on each side
to ensure adequate airflow.
An optional Air Filter is also available (see Section 7 for options).
3.4 COOLANT FILL
The coolant fill cap is located at the top rear of the unit. Twist off
the cap counter-clockwise to open. Fill reservoir to the bottom of the
neck prior to starting unit. Close cap before operating
Recommended Coolants:
Solid State Cooling Systems recommends using Koolance, a pre-
mixed 27% propylene glycol/water based coolant containing an
algaecide and corrosion inhibitors. Though it comes in several colors,
SSCS recommends the colorless or blue versions in 700 ml bottles,
part number: LIQ-702CL-B (clear) or LIQ-702B-B (blue), as the
dyes in the other colored versions can form small particulates when
not well mixed.
Contact Koolance for details:
Koolance USA
2840 West Valley Highway North
Auburn, WA 98001
(253) 893-7551
Water or ethylene glycol/water mixtures are also acceptable as
coolants.
Note that algae growth can occur when water is used without at
least 25% propylene or ethylene glycol.
To Next Page
Loading...
