Solid State Logic SSL UC1 User Manual

Troubleshooting & FAQs
37
SSL UC1 User Guide
UC1 LCD Messages
The UC1 screen will display various messages:
SSL UC1 Logo
This message is displayed when you power up UC1, accompanying the power up/light up sequence.
'Awaiting Connection to SSL 360° Software'
This message means that UC1 is waiting for the SSL 360° software to start running on your computer. You
may see this message appear when logging onto your computer, before the operating system has finished
loading your user-profile and start-up items. You may also see this message if you are yet to plug a USB
cable from your UC1 into your computer.
'No Plug-ins'
This message means that you are connected to SSL 360° but either the DAW is closed or, the DAW is open
but with no Channel Strip 2 or Bus Compressor 2 plug-ins instantiated.
'Attempting To Reconnect'
This message means that communication between SSL 360° and UC1 has been lost. If you experience
this, then check that your USB cable connecting UC1 and 360° has not been removed. Re-connect if so.

Solid State Logic SSL UC1 Specifications

General

Brand	Solid State Logic
Model	SSL UC1
Category	Recording Equipment
Language	English