Solid State Logic SSL UC1 User Manual

Get-Started
7
SSL UC1 User Guide
Get-Started
Unpacking
The unit has been carefully packed and inside the box you will find the following items in addition to your UC1 control surface:
Fitting The Stands (Optional)
UC1 has been designed to be used with
or without the included screw-in stands,
depending on your preference. Attaching
the included screw-in stands has the added
benefit of angling the unit towards you.
Three different fixing positions (the holes
are arranged in pairs) allow you to choose
an angle that is best for your setup. Use 2
screws per stand. Please be careful not to
over-tighten to avoid stripping the screw
threads. For those with a torque measuring
device, tighten to 0.5 Nm.
Additional Elevation Angles
If you need a steeper angle of elevation, you can rotate the stands and fix them to the chassis using the shorter side. This gives
you three additional angle options to choose from.
1. Unscrew the rubber feet and move to the other end 2. Rotate the stands so that the short side fixes to the chassis
12 volts, 5 A Power Supply
and IEC Cable
1.5 m C to C USB Cable 1.5 m C to A USB Cable
2 x Stands
Short
Side
Long
Side
Long
Side
Short
Side
1 x Hex Key
4 x Screws

Solid State Logic SSL UC1 Specifications

General

Brand	Solid State Logic
Model	SSL UC1
Category	Recording Equipment
Language	English