4 .1 P rodu ct h andli n g
P lease revi ew t h e i nstru cti on below f or h andli n g t h e i n vert er:
1 Th e red ci rcles below den ote cu tou t s on t h e produ ct pack ag e.
P u sh i n t h e cu tou t s to f orm h andles f or m ovi n g t h e i nvert er ( see Fi g u re 4 .1 ) .
3
Fi g u re 4 .1 m ove t h e i nverter
2 .O pen t h e cart on , th en h andle bot h si des of i n vert er t h rou g h t h e area den oted dott ed li ne.
( see f i g u re 4 .2 ) .
Fi g u re 4 .2 Inverter h andles
4 .2 P rodu ct St orag e
St orag e tem peratu re m u st be bet w een -4 0℃ an d 70℃ an d th e h u m i di ty m u st be
betw een 0 and 1 00% n on -condensi ng .
St ack n om oreth anth ree( 3 )i n vert ersh i g h .
If th e i nvert er i s n ot t o be i n st alled i m m edi at ely, storag e i nst ru cti on s an d en vi ron m en t al
con di ti ons are below :
Use t h e ori g i n al box to repack ag e t h e i nvert er, seal w i th adh esi ve tape w i th t h e
desi ccant i n si de t h e box.
St ore t h e i nvert er( s) i n a clean an d dry place, f ree of du st and di rt.
Keep box( es) aw ay f rom corrosi ve m ateri als to avoi d dam ag e t o t h e i n vert er enclosu re.
In spect pack ag i ng re g u larly. If pack ag i n g i s dam ag ed( w et , pest dam ag e, et c) ,
re pack ag e t h e i nvert er i m m edi at ely.
St ore t h e i nvert er( s) on a flat , h ard su rf ace - not i n cli ned or u psi de dow n.
A f t er lon g -t erm storag e, th e i nvert er ne eds to be f u lly exam i n ed an d t ested by q u ali fied
servi ce or t ech ni cal person n el bef ore u si ng .
R est arti n g af ter a long peri od of n on -u se req u i res t h e eq u i pm ent to be i nspect ed
an d, i n som e cases, t h e rem oval of oxi dati on and du st th at h as set t led i n si de t h e
eq u i pm ent w i ll be req u i red.
4 . Installati on4 . In stallat i on
.9..8.
To Next Page
Loading...
Need help?
General