2.3 Notice For Use
The inverter has been constructed according to the applicable safety and technical
guidelines. Use the inverter in installations that meet the following specifications only:
1. Permanent installation is required.
2. All components must remain within their permitted operating ranges and their
installation requirements at all times.
3. The product must only be used in countries for which it is approved or released by
Solis and the grid operator.
4. Use Solis products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and
directives. Any other application may cause personal injury or property damage.
5. This document does not replace any regional, state, provincial, federal or national laws,
regulations or standards that apply to the installation, electrical safety and use of the
product. Solis assumes no responsibility for the compliance or non-compliance with
such laws or codes in connection with the installation of the product.
6. The electrical installation must meet all the applicable regulations and standards.
7. The inverter must be installed according to the instructions stated in this manual.
8. The inverter must be installed according to the correct technical specifications.
9. To startup the inverter, the Grid Supply Main Switch (AC) must be switched on, before
the solar panel's DC isolator shall be switched on. To stop the inverter, the Grid Supply
Main Switch (AC) must be switched off before the solar panel's DC isolator shall be
switched off.
2.4 Notice for Disposal
This product shall not be disposed of with household waste. They should
be segregated and brought to an appropriate collection point to enable
recycling and avoid potential impacts on the environment and human health.
Local rules in waste management shall be respected .
2. Safety & Warning
User Manual
8
To Next Page
Loading...
