Adjusting the image size and position
1. Select Menu > Size & Position > Size Presets.
2. Select the appropriate size preset:
•
Auto—Display with the detected size.
•
Native—Display in its native resolution.
•
4:3—Retain 4:3 aspect ratio.
•
Letterbox—Make the active content enlarge to the full screen.
•
Full Size—Fill the screen, regardless of the source.
•
Full Width—Fill display width and keep aspect ratio.
•
Full Height—Fill display height and keep aspect ratio.
•
Custom—Stretch the display horizontally and vertically without cutting the image
display.
•
3D Mode—Display 3D content. All other items are grayed out, if 3D Mode is selected.
3. To confirm the selection, press ENTER.
Adjusting pixel phase
Adjust the pixel phase when the image shows shimmer or noise. Pixel phase can adjust the phase of
the pixel-sampling clock relative to the incoming signal. This feature is for analog RGB signals only.
1. Select Menu > Size & Position > Pixel Phase.
2. Adjust the slider by arrow keys or press ENTER to input the values of pixel phase.
3. After inputting the value, press ENTER to apply.
Setting the position of display image
Move the image vertically or horizontally to correct the position of the display image.
1. Select Menu > Size & Position > Horz Position or Vert Position.
2. Adjust the slider by arrow keys or press ENTER to input the values of moving pixels.
3. After inputting the value, press ENTER to apply.
Setting the digital size of display image
These functions are similar technologies as in-camera image processing. Use Digital Horz Zoom or
Digital Vert Zoom to enlarge or to compress the display image horizontally or vertically.
1. Select Menu > Size & Position > Digital Horz Zoom or Digital Vert Zoom.
2. Adjust the slider by arrow keys or press ENTER to input the value you selected.
3. After inputting the value, press ENTER to apply.
To Next Page