SONNOC SNP-LU850E - Setting up Password Protection; Changing Password; Setting up Power Mode; Setting the Standby Mode

Configuring system settings
Sonnoc User Manual
45
• Off
• 1 Min
• 3 Min
3. Press ENTER.
Setting up password protection
Protect your projector with a password. Once enabled, you must enter the password before you can
project an image. If the projector is powered on with password protection, you must enter the
password to use the projector.
1. Select Menu > Configuration > Menu Preferences > PIN Protect.
2. Enter a password by number keys.
3. To confirm the password, select OK.
Changing password
Change the current password to a new password.
1. Select Menu > Configuration > Menu Preferences > Change PIN.
2. Enter current password by number keys.
3. Select OK.
4. Enter new password by number keys.
5. Select OK.
6. To confirm the password, enter new password again by number keys.
7. Select OK.
Setting up power mode
Adjust various projector's power settings including the shutdown time, sleep timer, and standby
mode.
Setting the standby mode
Determine which standby mode the projector is in when AC power on.
1. Select Menu > Configuration > Power Management > Standby Mode.
2. Select the appropriate mode:
• 0.5W mode—Less power consumption (<0.5W) which does not have the ability to
monitor the projector over a network cable.
• Communication mode—More power consumption in standby mode which allows you to
monitor the projector over a network cable.