SONNOC SNP-LU850E - Setting the Wall Color; Adjusting the Color Value Based on Gamma Setting

Adjusting the image settings
Sonnoc User Manual
39
9. To edit gain of the primary, adjust the slider or enter the color values of the primary color
component you selected until you are satisfied with the colors.
Increasing value indicates increasing the lightness, and decreasing the value indicates
decreasing it to black.
10. To confirm your selection, press ENTER.
11. Repeat steps 3 to 9 for each primary color component, except white.
12. To edit the color of white by three components—red, blue and green—adjust the slider or enter
the values until you are satisfied with the white.
13. To confirm your selection, press ENTER.
14. To reset the primary colors to their defaults, select Reset to Default.
15. To reset back to default setting, press ENTER.
Setting the wall color
Set the wall color so the projector can enhance the color performance customized for the specific
wall.
1. Select Menu > Image Settings > Color Matching > Wall Color.
2. Select the preferred setting:
• White
• Gray 130
• Light Yellow
3. Press ENTER.
Adjusting the color value based on gamma
setting
Adjust the color values to give a more detailed displayed image.
1. Select Menu > Image Settings > Advanced Image Settings > Gamma.
2. Select the appropriate option:
• Video
• Film
• Bright
• CRT
• DICOM
3. Press ENTER.