Adjusting the image size and position
Enabling basic image blending
Configure blends directly on the projector to increase or decrease the borders of an individual image,
so it blends with a neighboring image to create a single, seamless image.
You can set blends on a projector when not using Sonnoc Twist and Mystique. Connecting to Twist
and Mystique grays out the blend settings on the projector.
1. Select Menu > Size & Position > Geometry Correction > Blend Area.
2. Choose a side to blend in with the other projectors.
3. To set up the starting position, select Start Pixel.
4. Adjust the slider by arrow keys or press ENTER to input the starting position.
5. After inputting the starting position, press ENTER.
6. To set up the size of blend area, select Pixel Height.
7. Adjust the slider by arrow keys or press ENTER to input the width of blend area.
8. After inputting the size of blend area, press ENTER.
9. To set the gamma value of the blend area, select Blend Gamma.
10. After selecting a gamma value, press ENTER.
11. To apply the settings, select Enable.
12. Press ENTER.
13. To save the blend setting, select Menu > Size & Position > Geometry Correction > Blend
Memory > Save Blend.
14. To set up the other side of blend area, repeat step 2 to 13.
To Next Page