Configuring
communications
Define and control how single or multiple projectors are linked with each other and with controlling
device.
Setting network environment
Determine the communication settings such as network setup, serial port information, and so on.
Adjusting LAN setting
Set up network configuration for wire networking.
1. Select Menu > Configuration > Communications > LAN.
2. Set up the appropriate setting:
•
MAC Address—Display the network MAC address value.
•
Network Status—Connect or disconnect Network status.
•
LAN Interface—Choose from RJ-45 or HDBaseT.
•
DHCP—Enable or disable the DHCP to automatically get IP address, subnet mask, and so
on.
•
IP Address—Assign the network IP address.
•
Subnet Mask—Assign the network subnet mask.
•
Default Gateway—Assign the network default gateway.
•
Primary DNS—Assign the primary DNS.
•
Secondary DNS—Assign the secondary DNS.
3. To apply the LAN settings, select Apply.
To Next Page