Configuring light source
Learn how to configure the light settings.
Setting light source
Set up the light source to control the projector brightness.
1. Select Menu > Light Source > Light Source Mode.
2. Set up the appropriate light source model:
•
Constant Power—Enable Constant Power to set the projector brightness to a specific
level controlled by the laser diode power. See
Setting constant power on page 57 for
more details of setting the laser diode power.
•
Constant Intensity—After enabling Constant Power, select Constant Intensity to
maintain current constant brightness and color settings. This function can remain at the
current setting for longer period of time than Constant Power mode.
•
Light sensor calibration must be performed before enabling Constant Intensity and is used for
long-term projecting or blending purposes.
•
When Constant Intensity is enabled, Dynamic Black and Real Black functions are automatically
disabled.
•
When Picture Settings is changed under Constant Intensity, the light source mode automatically
changes to Constant Power.
•
ECO 1 (80%)—Set the projector to 80% constant brightness and color settings.
•
ECO 2 (50%)—Set the projector to 50% constant brightness and color settings.
3. Press ENTER.
To Next Page