Sontex Supercal 5 - General and Pre-Installation Procedures; General Installation Conditions; Pre-Installation Requirements

6 Installation guide | Supercal 5
Installation guidelines for thermal energy
meter Supercal 5
General
The static ow sensor and its calculator may only be operated within the con-
ditions outlined on the identication plate, as well as within the technical spec-
ication! In the case of ignoring these default conditions, the manufacturer’s
responsibility is void and null.
The manufacturer is not liable for inappropriate installation and operation. Seals
may not be removed and/or only by authorized persons. The country-specic,
local regulations, as well as the manufacturer instructions, must be respected!
If the manufacturer’s seal has been broken or damaged, the manufacturer cannot
be made responsible for the change of the veried and meas-uring relevant data.
When using several heat meters in an installation unit, fair heat consumption
measurement muss be chosen. All of them in the same types of device and in-
stallation positions
Before installation

Check the design layout data of the installation.

The pulse value of the calculator and the installation location must match
the values indicated on the ow sensor, consult the identication plate!

The permissible ambient temperature range of the calculator is 5 – 55ºC.

The installation and project prescriptions must be followed.

The readability of the calculator and also the identication plates must be
followed.