Help Guide
Interchangeable Lens Digital Camera
ILCE-7CM2 α7CII
Auto Framing Settings
During movie recording or streaming, the camera automatically changes the composition by following the recognized
subject and cropping so that even if the camera is fixed, you can shoot with camera-work (auto-framed shooting).
You can set the timing to start shooting with [Auto Framing], the size of the subject on the screen, etc.
This function cannot be used during slow-motion/quick-motion shooting or time-lapse shooting.
Menu item details
Auto Framing:
Sets whether to automatically frame shooting. When [On] is selected, the composition is automatically set so that the
recognized person or touch-tracked subject is in the center of the screen. ([On]/[Off])
Framing Oper. Mode:
Sets the start method and operating method for [Auto Framing].
Start When Tracking : Auto-framing starts at the same time as tracking starts with touch tracking, etc.
Auto Start : Auto-framing starts when the subject is recognized.
Auto Start(15s swtc) : When the subject is recognized, the camera repeats camera-work that smoothly switches
between the cropped angle of view and the full angle of view at 15-second intervals.
Auto Start(30s swtc) : When the subject is recognized, the camera repeats camera-work that smoothly switches
between the cropped angle of view and the full angle of view at 30-second intervals.
Crop Level:
Sets the displayed size of the subject within the cropped frame after recognizing the subject. ([Large crop level]/[Medium
crop level]/[Small crop level])
When [
Recognition Target] is set to [Human], the cropped frame size changes dynamically according to the
recognition frame. If [
Recognition Target] is set to an item other than [Human], the cropped frame size will be locked.
MENU →
(Shooting) → [Shooting Option] → [Auto Framing Settings] → [Auto Framing] → [On].
1
MENU →
(Shooting) → [Shooting Option] → [Auto Framing Settings] → Select an item to set, and
then select the desired setting.
2
Start shooting or streaming.
A cropping frame is displayed on the monitor screen and follows the movement of the subject.
When [Touch Operation] is set to [On], you can select the subject of automatic framing using touch operations.
3
To Next Page
Loading...
Need help?
General
