Help Guide
Interchangeable Lens Digital Camera
ILCE-7CM2 α7CII
Bulb shooting
You can shoot a trailing image of the movement of a subject with long exposure.
Bulb shooting is suitable for shooting trails from stars or fireworks, etc.
Hint
When shooting fireworks, etc., focus at infinity in manual focus mode. If you use a lens whose infinity point is unclear, adjust the
focus on the fireworks in the area you want to focus on in advance.
In order to perform bulb shooting without causing the image quality to deteriorate, we recommend that you start shooting while
the camera is cool.
During bulb shooting, images tend to blur. It is recommended that you use a tripod, a Bluetooth remote commander (sold
separately) or a remote commander equipped with a lock function (sold separately). When using the Bluetooth remote
commander, you can start bulb shooting by pressing the shutter button on the remote commander. To stop bulb shooting, press
the shutter button on the remote commander again.
Note
The longer the exposure time, the more noise will be visible on the image.
You cannot set the shutter speed to [BULB] in the following situations:
When the drive mode is set to the following:
[Cont. Shooting]
[Self-timer(Cont)]
[Cont. Bracket]
[Shutter Type] is set to [Electronic Shutter].
[Silent Mode] under [
Silent Mode Settings] is set to [On]
If you use the above functions when the shutter speed is set to [BULB], the shutter speed is temporarily set to 30 seconds.
Set the Still/Movie/S&Q dial to
(Still) to select the still image shooting mode.
1
Set the mode dial to M (Manual Exposure).
2
Turn the rear dial L clockwise until [BULB] is indicated.
3
Select the aperture value (F-value) using the front dial.
4
Press the shutter button halfway down to focus.
5
Press and hold the shutter button for the duration of the shooting.
As long as the shutter button is pressed, the image sensor is exposed.
6
To Next Page
Loading...
Need help?
General
