Help Guide
Interchangeable Lens Digital Camera
ILCE-7CM2 α7CII
TC/UB
The time code (TC) and the user bit (UB) information can be recorded as data attached to movies.
Menu item details
Time Code Preset:
Sets the time code.
User Bit Preset:
Sets the user bit.
Time Code Format:
Sets the recording method for the time code. (Only when [NTSC/PAL Selector] is set to NTSC.)
Time Code Run:
Sets the count up format for the time code.
Time Code Make:
Sets the recording format for the time code on the recording medium.
User Bit Time Rec:
Sets whether or not to record the time as a user bit.
How to set the time code (Time Code Preset)
How to reset the time code
How to set the user bit (User Bit Preset)
How to reset the user bit
MENU →
(Shooting) → [TC/UB] → Select a menu item and set the desired parameter.
1
MENU →
(Shooting) → [TC/UB] → [Time Code Preset].1.
Turn the control wheel and select the first two digits.
The time code can be set between the following range.
When [60p] is selected: 00:00:00.00 to 23:59:59.29
2.
When [24p] is selected, you can select the last two digits of the time code in multiples of four from 00 to 23 frames.
When [50p] is selected: 00:00:00.00 to 23:59:59.24
*
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel.3.
MENU →
(Shooting) → [TC/UB] → [Time Code Preset].1.
Press the
(Delete) button to reset the time code (00:00:00.00).2.
MENU →
(Shooting) → [TC/UB] → [User Bit Preset].1.
Turn the control wheel and select the first two digits.2.
Set the other digits following the same procedure as in step 2, then press in the center of the control wheel.3.
To Next Page
Loading...
Need help?
General
