Adjustment Using the Menus
33
When [D93], [D65], [D61], [D55], or [DCI] data is
changed, they are displayed as [D93*], [D65*], [D61*],
[D55*], or [DCI*].
For the XYZ format signal
When [DCI XYZ] data is changed, it is displayed as [DCI
XYZ*].
When [Contrast/Bright Hold] is set to [Off], the color
temperature data are displayed. The contrast data is
displayed as the picture preset data [Preset1] to [Preset5]
or [Preset(DCI)] set in the [Picture Preset] menu of the
[Channel Configuration] menu. To change the type of
the picture preset data, select from [Preset1] to [Preset5]
or [Preset(DCI)] in the [Picture Preset] menu (page 37)
of the [Channel Configuration] menu.
Submenu Setting
[Manual Adjust] Adjusts the color temperature using the
BRIGHT, CHROMA, PHASE, and/or
CONTRAST knobs.
When the item is selected, the color
temperature adjustment display
appears, and the [Red], [Green], and/or
[Blue] color temperature data to be
adjusted are displayed to allow gain or
bias adjustment. Select gain or bias
adjustment using the UP/DOWN
buttons.
The adjustable items and relevant knobs
are as follows:
To adjust [Red] (red): BRIGHT knob
To adjust [Green] (green):
CHROMA knob
To adjust [Blue] (blue): PHASE knob
To adjust brightness ([Red], [Green]
and [Blue] together): CONTRAST
knob
To hide the characters on the monitor
during manual adjustment
Set the CHAR OFF button of the
controller to on. As the characters on
the display are hidden, it becomes easy
to adjust the picture. To display the
characters, set the CHAR OFF button to
off.
To reset [Red], [Green], and [Blue] to
the value before adjustment
During [Red], [Green], and [Blue]
adjustment, you can press the
corresponding MANUAL button to
reset to the value before adjustment.
Pressing the MANUAL button of
CONTRAST resets all [Red], [Green],
and [Blue] to the values before
adjustment.
You cannot reset the setting after you
press the ENTER (Ent) button even if
you press the MANUAL button.
To cancel adjustment
Press the MENU button. The
adjustment data is cleared and the
setting returns to the previous value.
To confirm adjustment
Press the ENTER (Ent) button.
During adjustment, the screen saver is
activated automatically if the operating
conditions are met, regardless of the
setting of the screen saver function.
To Next Page
Loading...
