The Auto Off function does not operate.
The unit
is
turned on. The Auto Off function activates
after turning offthe unit.
-+
Turn off the unit.
CD
playback
The disc cannot be loaded.
• Another disc
is
already loaded.
• The disc has been forcibly inserted upside down or
in
the wrong
way.
The disc does not playback.
• Defective or dirty disc.
• The CD-Rs/CD-RWs are not for audio use (page 23).
MP3IWMAJAAC files cannot be played back.
The disc
is
incompatible with the MP3/WMNAAC
format and version. For details on playable discs and
formats, visit the support site.
MP3IWMAJAAC files take longer to play back
than others.
The following discs take a longer time to start
playback.
- a disc recorded with a complicated tree structure.
- a disc recorded
in
Multi Session.
- a disc to which data can be added.
The display items do not scroll.
• For discs with very many characters, those may not
scroll.
• "Auto Scroll"
is
set to "off."
-+
Set "Auto Scroll on" (page 20).
-+
Press and hold (
DSPUSCRl).
The sound skips.
• Installation is not correct.
-+
Install the unit at an angle
of
less than 45°
in
a
sturdy part
of
the car.
• Defective or dirty disc.
The operation buttons do not function.
The disc will not eject.
Press the RESET button (page 6).
The stations cannot be received.
The sound is hampered by noises.
• The connection
is
not correct.
-+
Connect a power antenna (aerial) control lead
(blue)
or
accessory power supply lead (red) to the
power supply lead
of
a car's antenna (aerial)
booster (only when your car has built-in FMlAM
antenna (aerial)
in
the rear/side glass).
-+
Check the connection
of
the car antenna (aerial).
-+
If
the auto antenna (aerial) will not go up, check
the connection
of
the power antenna (aerial)
control lead.
Preset tuning is not possible.
• Store the correct frequency
in
the memory.
• The broadcast signal is too weak.
Automatic tuning is not possible.
• Setting
of
the local seek mode is not correct.
-+
Tuning stops too frequently:
Set "Local on" (page 20).
-+
Tuning does not stop at a station:
Set "Local
off'
(page 20).
• The broadcast signal
is
too weak.
-+
Perform manual tuning.
During FM reception, the
"ST"
indication
flashes.
• Tune
in
the frequency accurately.
• The broadcast signal
is
too weak.
-+Set
"Mono on" (page 20).
An FM program broadcast
in
stereo
is
heard
in
monaural.
The unit is
in
monaural reception mode.
-+
Set "Mono
off'
(page 20).
USB
praYDack';i:4~T'"..
".>
.",:5';
...•.
",'
.>.~
You
cannot play back items via a USB hub.
This unit cannot recognize USB devices via a USB
hub.
Cannot play back items.
A
USB
device does not work.
-+
Reconnect it.
The USB device takes longer to play back.
The USB device contains files with a complicated tree
structure.
A beep sounds.
During playback, the USB device has been
disconnected.
-+
Before disconnecting a USB device, make sure to
stop playback first for data protection.
The sound is intermittent.
The sound may be intermittent at a high-bit-rate
of
more than 320 kbps.
-
27
To Next Page
Loading...
