Error displays/Messages
Checking
The unit
is
confirming the connection
of
a USB device.
- Wait until confirming the connection
is
finished.
iPod Communication Error
Due to incorrect connection, data did not transfer
successfully between the unit and iPod.
- Reconnect the iPod and select iPod.
Error*1
o The disc
is
dirty or inserted upside down.
*2
-Clean
or insert the disc correctly.
o A blank disc has been inserted.
o The disc cannot play due to a problem.
- Insert another disc.
o
USB
device was not automatically recognized.
- Reconnect it again.
o Press
~
to remove the disc.
Failure (Illuminates until any button
is
pressed.)
The connection
of
speakers/amplifiers
is
incorrect.
- See the installation guide manual
of
this model to
check the connection.
Failure (Illuminates for about I second.)
When the SAT tuner
is
connected, storing an
SAT
radio channel into a preset failed.
- Be sure to receive the channel that you want to
store, then try it again.
Hubs Not Supported
_ USB hub
is
not supported on this unit.
Load
The CD changer
is
loading the disc.
- Wait until loading
is
complete.
Local Seek
+/-
The local seek mode
is
on during automatic tuning.
NO Device
(SOURCE)
is
selected without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
- Be sure to connect a USB device and USB cable.
NO Disc
The disc
is
not inserted
in
the CD changer.
- Insert discs
in
the CD changer.
NO Magazine
The disc magazine
is
not inserted
in
the CD changer.
- Insert the disc magazine
in
the
CD
changer.
NO Music
The disc
or
USB device does not contain a music file.
- Insert a music CD
in
this unit
or
an MP3 playable
CD changer.
-Connect
a
USB
device with a music file
in
it.
NO Track
The selected item in the USB device does not contain
an album/track.
Not Supported
The connected USB device
is
not supported.
- For details on the compatibility
of
your
USB
device, visit the support site.
28
Offset
There may be
an
internal malfunction.
-Check
the connection.
If
the error indication
remains on
in
the display, consult your nearest
Sony dealer.
Overload
USB device
is
overloaded.
- Disconnect the USB device, then change the source
by pressing
(SOURCE).
- Indicates that the
USB
device
is
out
of
order,
or
an
unsupported device
is
connected.
Read
The unit is reading all track and album information on
the disc.
- Wait until reading
is
complete and playback starts
automatically. Depending on the disc structure,
it
may take more than a minute.
Push Reset
The CD unit, CD changer or USB device cannot be
operated due to a problem.
- Press the RESET button (page 6).
"L-L-
:
L-L-
" or
"-'-'
:
-'-'''
During reverse or fast-forward, you have reached the
beginning or the end
of
the disc and you cannot go any
further.
"6:.:.:.:."
Th~
character cannot be displayed with the unit.
*1 If
an
erroroccurs during playback
of
a
CD,
the disc
number
of
the CD does
not
appear in the display
*2 The disc number
of
the disc causing the error
appears in the display
If
these solutions
do
not
help
improve the situation,
consult
your
nearest Sony dealer.
If
you take the unit to
be
repaired because
of
CD
playback
trouble, bring the disc that was used at the
time the problem began.
To Next Page
Loading...
