20
GB
Making basic settings
When the system is turned on for the first time
after purchase, some basic settings are required.
Turning on the system
Press ?/1 (power).
The system turns on, and the STANDBY indicator
turns to green.
To turn off the system
Press ?/1 (power).
The system is turned off, and the STANDBY
indicator lights up in red. When the network
standby is set to “On,” the STANDBY indicator
lights up in amber, and the clock appears in the
display.
• Network Standby - “Off” (factory setting)
This standby mode consumes less power than
when network standby is set to “On,” though the
system takes more time to resume operations when
powered on again.
• Network Standby - “On”
In this standby mode, the system is connected to
the network and remains partially active to quickly
resume operations when controlled over the
network, or powered on again. To set the network
standby mode, see “Setting the network standby
mode” (page 53).
Receiving a DAB/DAB+ radio
station (CMT-G2BNiP only)
When you turn on the system for the first time after
you purchase the system, DAB Initial Scan starts
automatically, and a list of available services is
stored.
Do not press any button on the unit or the remote
during the DAB Initial Scan. If you do so,
scanning will be interrupted and the service list
may not be properly created.
To start the DAB Initial Scan manually, perform
the procedure of “Performing a DAB Initial Scan
manually” (page 31).
Setting the clock
The time on the clock must be set correctly for the
timer function.
1
Press ?/1 (power) to turn on the
system.
To Next Page
Loading...
Need help?
General
