33
GB
Operations
Listening to an iPod or iPhone
You can operate your iPod/iPhone using the
remote and listen to music and other audio content
stored on your iPod/iPhone.
1
Select the USB function.
2
Connect the iPod/iPhone to the
(USB) port using the USB cable
supplied with your iPod/iPhone.
3
Press N to start playback.
Other operations
To use the system as a battery
charger
You can use the system as a battery charger for an
iPod/iPhone when the system is on.
Connect the iPod/iPhone to the (USB) port
using the USB cable supplied with your iPod/
iPhone. The charge status appears in the iPod/
iPhone display. For details, see the user’s guide of
your iPod/iPhone.
To stop charging the iPod/iPhone
Remove the iPod/iPhone. Turning off the system
also stops charging the iPod/iPhone.
Notes
• If the battery of the iPod/iPhone is empty, the system
may not recognize it. In such a case, recharge it with a
computer, etc. then connect it to the system.
• The performance of the system may be vary, depending
on the specifications of your iPod/iPhone.
• Do not carry the unit with an iPod/iPhone set on the
connector. Doing so may cause a malfunction.
• Before disconnecting the iPod/iPhone, pause playback.
• Hold down ./> to search forward or backward
while playing a video if m/M does not function.
• Because the operation of the system and the iPod/
iPhone are different, you may not operate the iPod/
iPhone using buttons on the remote or unit. In this case,
use control buttons on the iPod/iPhone.
• When the iPhone is connected to the system and you
receive a call during playback, playback will pause and
you can take the incoming call.
• To change the volume level, press VOLUME +/– on the
remote. The volume level will not change when
adjusted on the iPod/iPhone.
• To use an iPod/iPhone, refer to the operating manual
supplied with your iPod/iPhone.
• Sony cannot accept responsibility in the event that data
recorded on the iPod/iPhone is lost or damaged when
using an iPod/iPhone with this unit.
• The PLAY MODE button and the REPEAT button on
the remote do not work when the iPod&iPhone is
selected as the function.
To Do the following:
Pause playback Press X (pause). Press X or
N to resume playback.
Select a track or
chapter of audiobook/
podcast ./>
To fast-forward or
fastrewind, hold down the
button.
Find a point in a track
or chapter of
audiobook/podcast
Hold down m/M during
playback, and release the
button at the desired point.
Choose the selected
item
Press ENTER.
Scroll up/down the
iPod menus
Press M/m
Return to the previous
menu or select a menu
Press BACK.
To Next Page
Loading...
Need help?
General
