21
GB
Getting started
2
Press TIMER MENU to select the
clock set mode.
If “PLAY SET?” flashes, press M/m
repeatedly to select “CLOCK SET?,” then
press ENTER.
3
Press M/m repeatedly to set the
hour, then press ENTER.
4
Use the same procedure to set the
minutes.
To display the clock
Press DISPLAY while the system is off.
The clock is displayed for about 8 seconds.
Notes
• If “Network Standby” is set to “On” and the system is
turned off, the clock display appears.
• The clock settings are lost if you unplug the power cord
or if a power failure occurs.
Turning off the automatic
standby function
This system is equipped with an automatic standby
function. The system enters standby mode
automatically after about 30 minutes if there is no
operation or audio signal output.
By default, the automatic standby function is
turned on.
Use the buttons on the unit to turn off the
automatic standby function.
Hold down ?/1 while the system is on
until “AUTO STANDBY OFF” appears.
To turn on the function
Repeat the procedure until “AUTO STANDBY
ON” appears.
Notes
• “AUTO STANDBY” appears on the display for
2 minutes before the system enters standby mode.
• The automatic standby function is invalid for the tuner
(FM/AM/DAB) function, even if you have enabled it.
• The system may not enter standby mode automatically
in the following cases:
– when an audio signal is detected.
– during playback of audio tracks or files.
– when a preset Play Timer or Sleep Timer is on.
To Next Page
Loading...
Need help?
General
