Sony HCD-SHAKE5 - Page 56

HCD-SHAKE5/SHAKE6D
56
Pin No. Pin Name I/O Description
52 O-ANALOG-ASEL O Multiplexer selector A for Analog input
53 O-ANALOG-CSEL O Multiplexer selector C for Analog input
54 O-VIDEO-MUTE O Video Mute. "L" : mute On
55 O-MTK-BUSY O BUSY Signal communication between MTK
56 I-MTK-XIFCS I MTK CHIP SELECT
57 O-MTK-RESET O MTK Reset Pin
58 O-CD-MOTOR + O CDM turning motor control signal output
59 O-CD-MOTOR - O CDM turning motor control signal output
60 VCC I Power supply terminal (+3.3V)
61 O-DIGITAL-SEL O Digital Selector Pin
62 VSS I Ground terminal
63 I-CDM-LOAD-SW I CDM LOAD SW
64 I-CDM-UNLOAD-SW I CDM UNLOAD SW
65 AD-KEY0 I Key input terminal (A/D input)
66 I-DSP-INT I DSP Initialization completion interrupt signal
67 O-DSP-MUTE O DSP Mute control . "H": Mute On
68 /I-FAN-BLOCK I Fan Block Detection Pin. "L": Block On
69 I-FAN-DRIVE I Fan on/off control input signal. "H": On
70 /I-THERMISTOR-DET I Temperature protect pin. "L": Protect on
71 /I-DC-DET I DC detection pin. "L": Protect on
72 I-DAMP-OCP I Digital Amp over current protection pin. "L": Protect on
73 O-DAMP-RESET O Digital Amp Reset Pin
74 /I-SD-FAST I Power Supply Shutdown Protection Detection Pin. "L": Protect on
75 I-DSP SDA I DSP IC: Data signal for IIC communication
76 I-DSP SCL I DSP IC: Clock signal for IIC communication
77 NO-USE O NO USE
78 O-PCONT-DAMP O Digital Amp Module Power Control Pin. "H": ON
79 O-MTK-POWER-CTRL O Power Control pin for MTK
80
O-RGB-TRANS-LED-
SPK
O Transfer signal to RGB driver (driver for Speaker LED)
81 NO-USE - Not used
82 NO-USE - Not used
83 NO-USE - Not used
84 /I-HUB-OC-USB B I USB Overcurrent Detection input port B
85 O-VBUS-OE O MTK Vbus Output enable control pin
86 /I-HUB-OC-USB A I USB Overcurrent Detection input port A
87 O-HUB-VBUS-DETECT O Hub Power (V-DET) Control Port
88 O-HUB-RESET O MTK Hub reset pin
89 NO-USE - Not used
90 I-AD-KEY-1 I Key input terminal (A/D input)
91 I-MIC-DETECT I Mic Input Detection pin. "H": Mic detected
92 I-MASTER-VOLUME I Jog dial pulse input from the MASTER VOLUME encoder (A/D input)
93 O_PCONT_BTSTBY O BT Standby Power Control Pin. "H": ON
94 AVSS I Ground terminal
95 I-MODEL-DEST IN I Model and Destination setting terminal (A/D input)
96 VREF I A/D Converter reference voltage input terminal (+3.3V)
97 AVCC I Power supply terminal (+3.3V)
98 O-FL-LATCH O Data Latch signal to FL CIG
99 O-FL-SOUT O Serial data output to FL CIG
100 O-FL-CLK O Serial clock output to FL CIG