Sony HT-SF2000 - Disc Player

If you connect a Blu-ray disc
player
Be sure to change the factory setting of the
VIDEO 2 input button on the remote so that
you can use the breton to control your Blu-ray
disc player. For details, see "Changing button
assignments" (page 59).
Notes on HDMI connections
• Use a HDMI cable with the HDMI logo
(made by Sony).
• An audio signal input to the HDMI IN jack
is output from the SPEAKERS jacks and
HDMI OUT jack. It is not output from any
other audio jacks.
• Video signals input to the HDMI IN jack can
only be output from the HDMI OUT jack.
• When you want to listen to the sound from
the TV speaker, set "AUDIO" to
"TV+AMP" in the VIDEO menu (page 41 ).
If you cannot play back multi channel
software, set to "AMP". However. the sound
will not output from the TV speaker.
• The multi/stereo area audio signals of a
Super Audio CD are not ompm.
• Be sure to turu on the receiver when the
video and audio of a playback component
are being omput to a TV via the receiver. If
the power supply of the receiver is not
tin'ned on, neither video nor audio is
transmitted.
• Audio signals (sampling frequency, bit
length, etc.) transmitted from a HDMI jack
may be suppressed by the connected
component. Cheek the setup of the
connected component if the image is poor or
the sound does not come om of a component
connected via the HDMI cable.
• Sound may be interrupted when the
sampling frequency or the number of
channels of audio output signals from the
playback component is switched.
• When the connected component is not
compatible with copyright protection
technology (HDCP), the image and/or the
sound from the HDMI OUT jack may be
distorted or may not be omput.
In this case, check the specification of the
connected component.
• Set the resolution of the image of the
playback component to 720p or 1080i when
you output 96 kHz multi channel sound over
a HDMI connection.
• We do not recommend using a HDMI-DVI
conversion cable. When you connect a
HDMI-DVI conversion cable to a DVI-D
component, the sotmd and/or the image may
not be output.
• For details on HDMI setup of the connected
component, refer to the operating
instructions supplied with the connected
component.
22cs