Numeric
buttons
ENTER
2
1
2
Press TUNER repeatedly to
select the FM or AM band.
Press PRESET + or PRESET -
repeatedly to select the preset
station you want.
Each time you press the button, you call
select a preset station as follows:
_ 0 , --(,2 _;,;2f,;_i,;7 .... 27_
You can also press the numeric buttons to
select the preset station you want. Then.
press ENTER to enter the selection.
Using the controls on the
receiver
1 Press INPUT SELECTOR repeatedly to
select the FM or AM band.
2 Press PRESET TUNING + or PRESET
TUNING - repeatedly to select the preset
station you want.
Usingthe RadioData
System(RDS)
(Models of area code CEL, CEK
only)
This receiver also allows you to use RDS
(Radio Data System), which enables radio
stations to send additional information along
with the regular program signal. You can
display RDS information.
Notes
• RDS is operable only for FM stations.
• Not all FM stations provide RDS service, nor do
they provide the same type of services. If you are
not familiar with the RDS services in your area,
check with your local radio stations for details.
Simply select a station on the FM
band using direct tuning (page 50),
automatic tuning (page 49), or
preset tuning (page 52).
When you tune in a station that provides RDS
services, "RDS" lights up and the program
service name appears on the display.
Note
RDS may not work properly if the station you tuned
to is not transmitting the RDS signal woperly oz"if
the signal strength is weak.
52Ge
To Next Page
Loading...
