Changingbutton
assignments
You can change the factory settings of the
input buttons to suit the components in your
system. For example, if you connect a DVD
recorder to the VIDEO 1jacks on the receiver,
you can set the VIDEO 1button on this remote
to control the DVD recorder.
1 Hold down the input button of
which you want to change the
assignment.
Example: Hold down VIDEO 1.
2 Referring to the table below,
press the corresponding
button for the category you
want.
Example: Press 4.
Now you can use the VIDEO 1 button to
control the DVD recorder.
Categories and the
corresponding buttons
Categories Press
VCR (command mode VTR 3) a) 1
VCR (command mode VTR 2) a) 2
DVD player/DVD recorder 3
(command mode DVD 1)b_
DVD recorder 4
(command mode DVD3)b_
CD player 5
Euro Digital Satellite Receiver 6
DVR (Digital CATV terminal) 7
DSS (Digital Satellite Receiver) 8
BIu-ray disc player 9
(command mode BD 1)c)
BIu-ray disc recorder 0/10
(command mode BD3) c)
TV -/--
Not assigned ENTER/
MEMORY
a!Sonv VCRs are operated with a VTR 2 or VTR 3 C
setting which correspond to 8 mm and VHS "_
respectively.
b_Sony DVD recorders are operated with a DVD 1 or
DVD3 setting. For details, refer to the operating
instructions supplied with the DVD recorders. 3
C!For details on the BD1 or BD3 setting, refer to the O
operating instructions supplied with the Blu-ray _"
disc player or Blu-ray disc recorder.
To clear all remote button
assignments
Press I/(_), DMPORT and MASTER VOL - at
the same time.
The remote is reset to its factory settings.
5g_8
To Next Page
Loading...
