2
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
Press TUNING + or TUNING -.
Press TUNING + to scan from low to
high; press TUNING - to scan from high
to low.
The receiver stops scanning whenever a
station is received.
In case of poor FM stereo
reception
If the FM stereo reception is poor and "ST"
flashes on the display, select monam'al audio
so that the sound will be less distorted. '1
To select monaural audio, you can
- press FM MODE repeatedly until the
"MONO" indicator lights up on the display.
- set "FM MODE" in TUNER menu to "FM
MONO" (page 40). 2
To return to stereo mode, you can
FM MODE repeatedly until the
press
"MONO" indicator on the display do not
light up.
- set "FM MODE" in TUNER menu to "FM
AUTO" {page 40).
You can enter the frequency of a station
directly by using the numeric buttons.
4
Press TUNER repeatedly to
select the FM or AM band.
You can also use INPUT SELECTOR on
the receiver.
Press D.TUNING.
Press the numeric buttons to
enter the frequency.
Example 1: FM 102.50 MHz
Select 1 .*,0*2*5 *0
Example 2: AM 1,350 kHz
SeIectl*3*5*0
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
4 Press ENTER.
If you cannot tune in a station
Make sure you have entered the right
frequency. If not, repeat steps 2 to 4. If you
still calmot tune in a station, the frequency is
not used in your area.
50 ;8
To Next Page
Loading...
